rigid flex circuits boards assembly
This is a rigid flex circuits
(total thickness: 1mm on the round part, 0.5mm on the square part). No
components shall be placed on the PCB. See picture in the attached file
for proposed layer stack-up. Please see the picture below (the red line
represents the part that is flexible).
We want PCBA for this design. The difference since last time are a few resistor values and the “outer part” where there are no components has been changed.
This is a rigid flex circuits (total thickness: 1.5mm of the rigid part). On the quadrilateral side, the PCB has two layers, the outer part has only one upper layer, and a stiffener on the bottom, please see the illustration below. See proposed layer-stack-up in the attached file. NOTE that components with designators 807-22-001-30-001101, 807-22-001-30-001102, 807-22-001-30-001103, 807-22-001-30-001104 and R1 shall NOT be placed.
We would like all the PCBs to have black solder mask with white silk. HASL-LF surface finish is preferred.
We want PCBA for this design. The difference since last time are a few resistor values and the “outer part” where there are no components has been changed.
This is a rigid flex circuits (total thickness: 1.5mm of the rigid part). On the quadrilateral side, the PCB has two layers, the outer part has only one upper layer, and a stiffener on the bottom, please see the illustration below. See proposed layer-stack-up in the attached file. NOTE that components with designators 807-22-001-30-001101, 807-22-001-30-001102, 807-22-001-30-001103, 807-22-001-30-001104 and R1 shall NOT be placed.
We would like all the PCBs to have black solder mask with white silk. HASL-LF surface finish is preferred.
评论
发表评论